Ford Focus RS Forum banner

1 - 20 of 34 Posts

·
Premium Member
Joined
·
187 Posts
Discussion Starter #1 (Edited)
Exhaust Weight Compilation

Stock RS exhaust -
@Hank thanks! Midpipe: 8.2 lb + Rear section with muffler and motor assy: 33.2 lb = 41.4 lbs
soontors OEM = 40.8 lbs
DocWalt = 42.2 lbs

Agency Power Exhaust
@VividRacing & Agency Power = "whole exhaust around" 30lbs "including the clamps and tips"

AWE - Thanks @Josh/AWE!
AWE Track Edition: 28 lbs
AWE Touring Edition: 34.5 lbs
AWE SwitchPath™️: 38 lbs

Borla S-Type
@soontors thanks! 40.5 lbs
Borla Atak
@Patches Thanks! Box with exhaust: 51.0 lbs Box without exhaust: 11.2lbs Exhaust weight: ~40lbs

COBB
Everything together weighs ~ 60lbs?
[email protected]
Can anyone confirm this.

ETS Extreme, Non-resonated, no muffler
ETS Midpipe with Helmholtz resonator tube = 16.5 lb + ETS rear connector & hardware = 6.16 +
ETS Rear section without mufflers = 9.5 lb = 32.16 lb

ETS Non Extreme & Non-resonated - Thanks @Raptor911
ETS Midpipe with Helmholtz resonator tube = 17.1 lb
ETS Rear section connector (connects mid-pipe with rear section ) = 5.4 pounds
ETS Rear section = 16 pounds
Hardware = 2 pounds
Total = 40.5 pounds

Limited Run Titanium ETS, non-resonated, w/ mufflers
@DocWalt thanks! 19.4 lbs

Full Race
42 lbs Full Race Website info

Magnaflow
The kit's shipping weight is around 40lbs, so the system itself likely weighs between 30 and 35lbs from [email protected]
Shipping Weight: 18.2kgs from stratifiedauto

MBRP
Black Series Cat Back Exhaust System Thanks @MorningZ it weighs right around 50lbs

Mountune V2 Cat Back Exhaust Focus RS
"10% lighter" = 41 lbs - 10% = 36.9 lbs

Remus
@bad|teddythanks! Remus exhaust is 27.65 lbs.

Stainless Works
TJ Jordan from Stainless works: "55lbs for the whole system" - "downpipe weighs roughly 10lbs" = 45 lbs

Thermal
Break down of each piece below: 40.60625 lbs

Tune+ Thanks @TUNE+
TUNE+ Titanium Single Exit Catback - 7lbs without muffler, 9.12lbs with muffler TOTAL WEIGHT

Dowpipes
Stock Downpipe + bracket = 12.4 lb
Scorpion Downpipe = 6.16 lb
Stainless Works Downpipe = 10 lbs
 

·
Registered
Joined
·
968 Posts
Finished!
Have you installed it yet? I'm interested to see how much of a drone you get without any type of resonator. Looks fantastic!
 

·
Registered
Joined
·
911 Posts
ETS Non Extreme & Non-resonated
ETS Midpipe with Helmholtz resonator tube = 17.1 lb
ETS Rear section connector (connects mid-pipe with rear section ) = 5.4 pounds
ETS Rear section = 16 pounds
Hardware = 2 pounds
Total = 40.5 pounds.
 

·
Premium Member
Joined
·
187 Posts
Discussion Starter #7
AWE Exhaust Systems Added - Thanks @Josh/AWE!

AWE Track Edition: 28 lbs
AWE Touring Edition: 34.5 lbs
AWE SwitchPath™: 38 lbs
 

·
Premium Member
Joined
·
187 Posts
Discussion Starter #8 (Edited)
I really liked the Thermal Exhaust and their principles but not the weight. Here's a quick peek at TX1775 Modified Thermal.
View attachment 205930

Right at 30lbs, but expected to be lighter than AWE Track Edition once that big resonator is replaced :)
Side note: I would have probably bought AWE if it was out back then. Good stuff AWE! IMG_2348.JPG
 

·
Registered
Joined
·
288 Posts
Very light. I reached out to see if they would consider producing a dual exit exhaust if there's enough interest here. Even if it adds ~50% more weight, you're looking at half the weight of the lightest systems out there

Edit: the reply

Not at this time. We are only making the titanium catback in single to reduce the most weight possible.

If the single goes well, after the first of the year we will consider different variants.

The timeline is setup for this single, then intakes, then we’ll look at doing a dual.
 

·
Premium Member
Joined
·
3,291 Posts
It's official, Tune+ Ti is the lightest exhaust system for the RS! Weight was taken with a digital kitchen scale and may vary slightly from analog or shipping scale. Either way it is #hellalightweight!
Pictures failed. But I saw where they are also working on carbon fiber diffuser with single exit so it looks "more stock".
 

·
Premium Member
Joined
·
187 Posts
Discussion Starter #18
Admins any idea what happened to the images? All the images that was uploaded no longer exists in my attachments. Thank you!
 

·
Premium Member
Joined
·
187 Posts
Discussion Starter #19
Pictures failed. But I saw where they are also working on carbon fiber diffuser with single exit so it looks "more stock".
I'm not sure what's going on with Forum's System, but it seems to be hit or miss. I can still see some of the photos with my iphone, but I can't see anything with my laptop. Let's see if this works; reattaching Ti Photos for you @ControlNode :) 23915525_2196638883695009_8446956893927439473_n (1).jpg 23916012_2196638890361675_7639922651282096147_n.jpg 24174304_2196638957028335_8074419012100514445_n.jpg 24129840_2196638893695008_5189921693994772124_n.jpg
 

·
Registered
Joined
·
90 Posts
1 - 20 of 34 Posts
Top